great print on the a1mini, fits my dudes perfectly. would recommend printing on a textured surface i had some issues with the small supports lifting up about half way through through the print on a smooth surface plate.i would say though if you are looking to fit tennis/running shoes on this you may need to opt for a bigger printer or size up the print to accommodate larger shoes

took some work figuring out how to place the names and making sure everything was flush with the bed so no supports were needed. I followed someone else's advice and put a pause in the print at layer 10 to change from white to red filament. NO AMS needed.

perfect hangers, I used this for a coat hanger at the office in my cube

good print, I did end up breaking it. I think that's on me for over tightening

good print, I couldn't get it to work but I think I had issues getting my measurements right

quick fun print. ended up handing them out around the office for a little holiday decor

perfect fit

Definitely need to print in PETG or another high temp filament. works great, I did try in rainbow pla but it ended up warping in the car

did exactly what I needed which was plugging a hole in a plastic pumpkin

good print ended up sizing it down to more of a monopoly board peice and it still printed good. used bambu studios auto orientation and feel like it printed better than the standard mobile print

great print, ended up putting it onto the knitted elephant and was able to split the model up in bambu studio so I could print it two separate colors without an ams

love this print, the supports are a little tough to remove clean but its a good print. I ended up print the Santa hat and piecing it together, would love if there was a model that had them together like some of the other animals

great print, the only thing I would note is there seems to be alot of stray print strings at the bottom of the print when removing the brims and such from the model and lining up all the peices were a bit difficult.. it does look very good though, I printed two times, I ended up painted the eyes. would rate it 5 stars if we could get the eyes able to print as separate parts as well.

printed in clear/translucent pla love the look these provide, once we get our tree out we'll be hanging them on it for the season

printed really smooth and supports came of really easy. looks great in rainbow filament

wife wanted a small ratchet she could use and fit in her hand... this is perfect foe the job

printed all three work great

this worked great, love the flexibility of the actual slots and how they come together not allowing cables to just fall out like some other cable holders I've tried