Printed out fine but the slots are too small for my charging cord.

These are nice to use. I broke one of the attachment pieces but I’ve got no real complaints.

It is great to let my water bottles air dry, I am working on a way to get some air circulation in there to speed up the process.

I printed this out fo a professor and it was great

came out great but it was a bit too small for my iPhone 13 Pro Max with a Dbrand grip case. I can get it to fit but it is tight and the print flexes

printed out nice and easy

printed out great, I had bed adhesion issues but that was a me problem. Unfortunately I didn’t do the prep work so the spot I wanted to put it didn’t work.

printed out easy and looks nice.

Printed for a friend and they really enjoy it. print was quick and easy.

Cane out pretty good, it is currently in use. No complaints

works great in my 10 inch rack, one suggestion I would make is to adjust the profile so a m.2 to sata adapter can fit without needing an extension cable

Printed in PLA matte, it came out great, It can be tough to get the ptfe tubes in but overall I really like it.

came out great, I haven’t installed it yet but I’m liking it

The print came out okay for the most part, I did have some issues with supports coming off the print but other than that it was pretty good. The ball itself is very hard and can require some effort to squish.

Printed out great, only issues I have are just getting the microfiber in right but that is a me issue and no fault of the profile.

I don’t see how this could go wrong, it printed great.

Super cool, sorta impractical for me but it was a very fun project to work on. My filaments did not want to play nice with bed adhesion which lead to lots of messed up prints but that was no fault of the profile. The only issues I had were getting bearings and gears into place but I made it work. Even with bearings due to tolerances of the gears the crank can require a good bit of force.

Super useful in checking changes and diagnosing issues

Everything came out great. The bottom frame appears to be a little warped but I took it off when it was still hot so that is my fault, not the fault of the profile

it printed great and looks good too. There is a little flex when holding my iPhone 13 Pro Max which can cause it to slide off the magnets (I’m using an off brand MagSafe charger so I’m assuming the magnets in it are just weaker)