Prints pretty well, thread works well.

Bearing works reasonably well but support was a bit tricky to remove.

Printed well

Printed reasonably but some stringing. They work well!

Printed reasonably but with some stringing. Maybe it needs to run a bit slower?

Printed well and cleanly.

Print was good but it doesn't fit my whetstones!

Printed brilliantly and works really well!

Much better option than the last one I printed as it doesn't affect the poop leaving the extruder whereas the last one I used did.

Prints very well. I printed it in ABS so it's more childproof!

Printed in Prusament ASA orange as my old PLA ones were warping due to printing ABS and ASA. Printed well.

Printed in Prusament ASA Orange, printed very well, lined up well. It would be good to have information on which one is which as it was a bit of trial and error to get them into the right spots.

Prints well but I think I had an issue with the PETG that I used, Bambu Translucent, which caused it to not be watertight entirely.

Prints brilliantly in PLA!

Printed well but I didn't think to check the size of my mason jars before printing!

Printed perfectly in Bambu ABS, fits perfectly into my Aussie Mason brand jar which is a wide mouth jar!

Awesome design, I had to slightly grind down the 8mm aluminium rod I used for it so it might be worthwhile increasing hole size slightly with a ~0.1-0.2mm tolerance on the 8mm diameter for easier swinging.

prints in place brilliantly

probably would have printed better if my build plate was cleaner but the reprint turned out beautifully

printed brilliantly