Search models, users, collections, and posts
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Share
0
0
0
Share
0
0
0
used Bone colored PLA and it turned out awesome. I was worried about support removal damaging the flower but it came off no issues. Great model!
Share
0
0
0
great model. supports were significant as stated in the description. I had difficulty removing the supports particularly around the flower and it ended up breaking off. The print took 24 hours so I might try to glue instead of printing again.
Share
0
0
0
Probably the best St Michael Model I’ve found on maker world (in my very short time on the site/3d printing) I scaled this up 228% so it stands around 9 inches. lots of support removal (again relative to my experience). It’s not an exact match of the original (sword placement looks like he’s close to stabbing himself, back and Satans face lack detail even with printing at .12mm layer height) but it’s a great piece to my prayer area.
Share
0
0
0
No more data