The top part needs to be reworked and flattened to use it as support for 3D printing display.

I will retry with different orientation, it has a lot of supports that are hard to remove. I broke multiple teeth when removing support. The print itself is amazing.

If you scale it, make sure you keep the Z axis as is.

I wish this had an elastic mounting system to hold things down as I am using it in my car.

The version with the support ring at the bottom works better for terrariums

Great print, does not fit well with the diy case.

Printed perfectly, the Amazon remote is very loose in it.

Printed perfectly at 80% size on the A1 Mini

The thinner wall version with the normal deflector works well

The print came out really well, the only issue I had was with the assembly since I could not find any instructions. I was surprised by the dummy proof with the parts, the pins and screw points make it impossible to add a part on the wrong side.