Came out amazing! one really useful print for the P2S!

Printed great. Some slight imperfections in parts of the outer wall, but nothing major. Modified it for a prototype fidget clicker

Printed well. I just had challenges with the "skeleton" -- they seemed to be a tad too big (specially the arms) so they would not fit as is. Luckily, I had some spare parts from my prevous D13 prints and these fit very well. Still gave this 5 stars as it was not too bad and I appreciate the effort of the designer! Overall, still happy with the print!

Printed in PETG. Very happy with this! Simple and functional!

Printed well, although a bit of "anomaly" at one of the edges Lol Does not affect the functionality though. Still happy with this

Printed well! Just the right size for a Sunlu spool. Will print in PETG next

Printed well, snug fit!

Nice model! Good print although I had to sand the handles a bit (took just a few minutes to do so). Thanks for this!

Great print! Changed the Top Z distance setting for the supports to 0.27 to make support removal easier. Boosted! Thanks!

Nice print! I used PETG since I read the stock might break when peeling off the supports when using PLA. I adjusted the support Z distance to .27, but it still took a bit of effort to remove. Still a nice print! Boosted! Thanks!

Printed really well! Just be careful of the small antenna when handling -- I immediately broke it while taking of lf the supports Lol! Used PLA, will be printing in PETG next to see if it will be more sturdy. Boosted! Thanks for this!