Perfect fit for this old phone. It doesn’t even turn on anymore, but my kid likes playing with it. She asked for a new case and I am real glad Infound this file. Thank you very much. ELEGOO PLA purple on P2S

Looks great. parts fit well and a little glue locked them in tight. One corner lifted up, I think the tension pulled up the plate, then it worked out flush on the top. so no biggie. Bambu PLA yellow, ELEGOO PLA marble.

Turned out great. Lines and letters pop nicely. I may work the design a little to add magnets to the back side. Then it could be stored on the side of the machine.

Coming up on 6-weeks after the birth of my third child. My wife’s reaction was “WT actual F”. Job well done. IYKYK P2S, bambu PLA white, Silk red

Second batch. Works great on Bambu and ELEGOO.

Fit all three well. On my desk at work.

Looks great. Next one I am doing in marble PLA.

Printed clean. Sizes matched up great

Fit the hotend snuggly. I like the preloaded two tone. I did orange over blue. thank you.

Turned out sick in ELEGOO marble PLA! top ten prints so far. thank you for a great design. Lots of supports, but pulled off cleanly. only had to do a tiny bit of snipping.

Printed both sizes. Both turned out great. I was surprised how smooth the prints turned out. PLA white.

Perfect clips. for sure need to print a few more batches now that I’m acquiring more spools. Clips great to Bambu spools. PLA on P2S, fast and no issues.

Printed great. stores A LOT of poop. Slide angle works very well and I have yet to have anything stop or clog up the exit hole. PLA grey on P2S without any problems.

Printed quick and snapped on perfect. I put it on backwards like some other people, but by the time I realized, I was happy how it looked. great file. PLA orange worked perfect.

Very nice detail in this print. Special surprise for the wife since she thinks she’s not “cool” for driving a minivan.

Fit our gate well. I may add a Velcro strap around it because the 1.5yr old grabs it off the gate. Printed super solid and feels like it would hold up to some proper strain.

Turned out great. Silk red. The wife thought it was cute. Legs seem very secure and dangle nicely.

Turned out great. I used silk red for the top detail and it makes the whole thing pop. Setting were dialed in. Still five start worthy, but if I printed again, I’d make the area at the cutter a tiny bit bigger. My sharp end digs into the print.

perfect fit for everything. the added Bambu logo makes it look like a stock container. thank you

Turned out nice. P2S- Did Bambu PLA. Black, Grey, Orange and Red Silk. The silk looks so much nicer in person. The shape make the light really bounce off the sides. Great model.