TLDR; - It printed really well and looks great. I changed settings making it take 9 hour. The knees are a weak point when removing supports. I printed this on a P1S with Bambu PLA Silk South Beach and PLA Basic Black, Hot Pink, and Jade White without any calibrations. I changed quite a few settings from the profile that it loaded with (0.20mm Standard @BBL X1C). I'm including screenshots of the settings that were changed. I only had a little of the silk filament left and wanted to make sure that it printed really well in one go. Mainly, I slowed down for the outer walls, top surface, and support interface and increased the support angle to 50 just to make sure all of the little spikes and his hands were supported well. When I removed the bottom supports around his legs, it all came off in one piece taking one leg with it and barely leaving the other attached. They both split in the same spot along the bend in the knees. Other than that, all of the supports came off very easily.