A solid upgrade over the first version, and a great model overall. Prints perfectly in Bambu ASA. Brims and supports come off easily. I appreciate that the author responded to comments and made this half-height version. The only downside is that if you use activated alumina instead of silica beads, the funnel and filler points are a little tight and the media doesn't flow in smoothly, but I don't think the model could be made much wider.

Pretty amazing. Our first big multicolor print with the H2D. We used all Bambu filaments, the translucent teal is really nice. We set the top Z to .26 and supports came off fine, probably could have done .27. I would definitely recommend adjust purging volumes, it dumps a lot of filament when switching from back or orange to white, could probably save a lot of time. But overall a great model, no complaints.

Turned out great. If I were to print again, I’d increase first layer line width and/or flow ratio to help it all melt together on the plate a little better.

Turned out great in orange and green Sunlu HS matte petg, using generic petg HF profile. If I were to print again, I’d add more layers of green, this filament is a little translucent. Seems plenty stable when fully loaded. Holds the vision encoder plate fine, even with the protective plastic. If I could make any suggestions, it would be nice to have tiered height slots so the plates are easier to see and grab. And more slots!

Havent mounted it yet, but the print turned out beautiful in Bambu ABS silver with all the default settings.

really well designed, thanks