It's bigger than I expected, I'm looking forward to see the glazed result.

nice!

printed well and fits perfectly, thanks! I'll need to find a different solution though, because moving the curtain requires too much force.

I am already in love. Will report once I try it on clay.

Printed without problems and supports could be easily removed. Surface is very smooth! The rings and clamps do not fit unfortunately, so everything is loose and wobbly. I will try to print them again a fraction bigger. Have yet to try it with clay.

Really nice idea, the eggs printed fine! I wanted just 50 so I had the same problem a lot of the others had as well (mixed-up names and numbers), thus I'm giving only 4 stars. I will upgrade it if the numbering if the objects is corrected.

print went flawlessly and scaling seems fine. used it to trace a circle rather than cut one, worked as expected.

very nice box! screw-mechanism a bit tight at the start but closes without problemy.

Leicht zu drucken und der untere Teil lässt sich perfekt reinschieben. Mich stört, dass die Zahnbürsten beim Reinstellen ständig zur Seite rutschen, müsste mal das Gitter mit den Dellen ausprobieren.

print without problems and do their job. After a lot of uses some of them wear our and do not close that well anymore but I like them either way.

A bit tight on the radiator but works like a charm! Very useful. The mechanism to put the thing together is very nice.

Print went well (sunlu pla meta) and the press works like a charm. It is quite stiff and requires a lot of force to open. Our four-year-old can only manage it with considerable physical effort—but on the plus side, it doesn't break when he sits on it to press. 😂 One tip: if there are any leftovers inside and the press is stored closed, it forms an almost indestructible bond with the play dough. I'm glad the handle didn't break when I opened it. It's better to store it open or carefully remove all residue. As for the extrusion mould, we would love to have small holes as well - for spaghetti.

works soo well!

nice texture roller! worked fine for the vase I tried. (beginner)

Beautiful! printed the roof standing upright, that worked fine for me. Scaled-down to Z-scale so it would fit into the mountain landscape.

Used only one Number for a shared advent calender, worked flawlessly!

Printed the big version for a 5cm diameter tree stump. The thread on one screw broke when tightening it, but thanks to wooden spacers, the tree is still secure—so it works for us!

The print went flawlessly! I installed the spice rack inside a cabinet door. The jars fit perfectly into the rack and do not fall out when the door is opened. Nevertheless, it is advised to check that the jars are secure before applying the stickers, as some fit better in one direction than the other.

Prints very well! Had to try it immediately, the cutting went flawlessly despite very sticky dough. The print however is not very visible after baking, maybe I need to press even harder... for me it was easier to cut and transfer the pieces to the baking sheet and stamp there. Dough with 500g of flour was enough for approximately 18 Houses.

very nice! I went with gray as well and am very happy with the result. I think it's particularly brilliant that the switches remain anchored in the game board, that's one less thing to set up.