0.12mm layer, 2 walls, 15% infill

0.28mm layer, 2 walls, 15% infill

Print in Place frame version

0.16mm layer, 2 walls, 15% infill

(Basic version without reserved base snap-fit) 0.16mm layer height, 2 walls, 15% infill

Standard mesh

This is the support part of the drain rack 3.0

0.2mm layer, 2 walls, 15% infill

0.28mm layer, 2 walls, 15% infill

NEW!! Recommended print profile! 0.2mm layer, 4 walls, 15% infill

(Fast but less reliable version) 0.2mm layer, 4 walls, 15% infill

0.08mm layer, 3 walls, 15% infill

0.2mm layer height, 1 wall, 5% infill

0.2mm layer height, 2 walls, 15% infill (High-definition version, paid for the modeling software haha)

0.2mm layer height, 2 walls, 15% infill (a bit tight)

0.2mm layer, 2 walls, 5% infill

0.2mm layer, 2 walls, 5% infill

0.2mm layer, 2 walls, 15% infill

0.2mm layer, 3 walls, 15% infill

Jewelry box lid :) 0.2mm layer height, 2 walls, 15% infill