all in I had a few hiccups that I can only suggest were my error, the owner @By_Ced was beyond helpful and much appreciated when I asked questions he helped with my errors and even helped with some editing... Could not speak highly enough of his help. A definite boost from me. Sadly I didn't take photos yet and have eaten boost token about to expire, can put up picture later. Thanks again.

great print thank you

simple easy print thank you much appreciated.

Big fan!! this is a fun print, I did one for my monitor at home and both at work!!

love it thank you, would love to have a size options taller to hold more batteries, if I had the knowledge maybe you could? make it so the AAA can mount on the face of the AA optimizing space.. not sure if that would cause a weight issue but it was. thought. thank you love the model!

resized to 200% and use it as a rear view mirror hanger. wife loves it thank you

Love this!! I did shrink the eyes pieces, mouth and red face pieces 2% to help with the getting them in place. that was choice and operator issues not design or model. love all of your models thank you and so helpful when I asked for assistance... definitely a boost from me.

this thing is great!! I love the multi part and much appreciate the effort it takes to pull apart a model for that. Thank you

quick easy cheap and it worked thank you

these will be great for our cruise thank you

these are a little tough to squeeze for open but that gives me comfort knowing they won't fall apart.

my son seen these and said it was a must have. be careful pulling the supports from between the smaller clips at the bottom side broke one of our being a little too rough.

love the tie in to your desk clamp and it uses thank you

I put a negative space in the flat to minimize filament and mounted under our kitchen cabinets works perfectly thank you

simple print thank you

this guys is a beast I love it!! and always appreciate the multiple parts to avoid waste of filament and time. much appreciated will be boosting!!

I also had the ears fail as many show in the comments, switched it to 1/2 speed for the first few layers and it printed just fine. fitting the pieces are painfully tight but that is a plus in my book. Thank you for your share and efforts

love all of your wildlife stuff, Thank you.. I painted the base black maybe should have went with a brown but this turned out amazing much appreciated.

clean the plate well and this is an amazing print. this will be a big hit so far everyone loves this one. thank you