Lots of waste supports great design overall

Uses much filament. Extremely solid. Love the pattern on the base. I only wish the vertical inside lip was slightly smaller but this is a minor point.

Very well done. Do have room for the base in your cupboard.

Amazing Print. Cliff notes under the lid. Perfect alignment. Made for sleeved cards.

Excellent

WOW. I used to be on the M1A1 in the Army and this thing is so precise and clean! It even has the small cable we would use while climbing on the tank. Bravo!

Very good print. Extremely sturdy,....maybe too much so? Rock solid though.

Excellent. Would love to see more pinball or ball bearing designs. Master Chief? Skier with goggles? or used in the base of a figure to make it move about. had a toy as a child with a ball bearing underneath that skittered about.

Great. I did have to change my settings for PLA Matte for cooling too quickly near fan and getting a rough flat surface in the back corner with a .6mm nozzle. Configuration issue and not a design one.

exceptional design and detail

Exceptional