Creality - Adapter disc

The V-Spooler X excels at rewinding onto Extrudr or Bambu Lab spools.
However, due to their geometry and dimensions, Ender Creality spools are incompatible as target spools.
The two adapter discs fit into the center of Creality spools, enabling the use of empty Creality spools with the V-Spooler X.

Application requires one adapter on each side, as shown pre-positioned on the plate.

When inserting, ensure correct orientation of the adapter discs to allow filament insertion through the spool and adapter openings.

With the V-Spooler X you can superbly rewind onto Extrudr or Bambu Lab spools.

Due to the coil geometry and dimensions, however, Ender Creality spools do not clamp and work as target spools.

The two adapter discs fit into the center of the Creality spools, thus allowing these empty Creality spools to be used in the V-Spooler X mounted on the standard shaft.
Therefore, one disc on each side is needed, as positioned on the plate.

When inserting into the spool, ensure correct orientation of the adapter discs so that the filament feedstock can be inserted through the spool and adapter openings.