Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
1.7 h
1 plate
Open in Bambu Studio
Boost
50
181
26
11
214
174
Released
Description
This is a funnel to make it easier to pour the contents of a large flat pan into a container. In particular, if you are drying silica gel beads in such a pan in the oven, this funnel would make it easy to get the beads back into their containers. It was designed to fit on the corner of a standard aluminum sheet pan. The photos show a quarter-sheet pan for scale. It should work fine for other baking pans that are less than 2.5cm deep.
The print has brims turned on. My first try failed to print because the thin lip of the funnel was not enough to hold the model in place. It got loose, and made a pile of spaghetti before I stopped it. You may need a deburring tool or similar to clean off the brim.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (26)