Technic Brick Wireless Mouse

Brick Technic compatible Mouse (Kit 002)

Description:

This is a design for the 002 wireless Mouse kit that is compatible with brick systems as well as technic brick systems and allows for great fun during PC time.

Assembly:

The model is comprised of 3 parts, the top half, the base and the battery cover.

First put the electronics of the kit in the buttom part as described in Bambu Labs video on the 002 Kit

Follow the guide until minute 1:28

Then put the top part over it making sure the scroll wheel fits in the corresponding hole of the top part.

Finally screw it down with 4 of the screws that are part of the 002 Kit. One on each corner.

Trouble shooting:

If you can't press the screws trough the base part, use your screw driver to free the holes, in case filament got stuck in it during printing.

If the wheel doesn't turn well simply move if slightly to the left or right so it is nicely centred between the two clock buttons.

Important:

Sadly there was no space for creating a usb dongle holder.

As this is a 3D printed brick system putting pieces on and of might me a bit tighter than on non 3D printed brick sytems. Therefore have a bit of patients when putting parts on and of. When removing technic pins make sure to twist them slightly while pulling them out for easier removal.

You might want to use a flat tool to help removing parts.

Printing:

-0.2mm layer hight

-needs supports

-single build plate