komil

I have the Komil standing desk from VCM. Unfortunately, the descriptions here are misleading, as the table is 99cm high at its highest setting. To compensate for this, I designed risers for the upper tabletop

It was printed with PETG Basic White from Bambu Lab. For the support interface, I used PLA from Geeetech

The part should slide loosely into the square tubes of the table. Unfortunately, there are welds in different places. I have left recesses in the model for the “typical spots”. Should the weld spots on your table be in a different position or be thicker, you simply need to file a small corner off the bottom of the model. For this, I used an inexpensive nail file with 100/180 grit. The tabletop then slides in loosely

The screws on the side can also be reattached for decoration. To do this, simply drill a suitable hole in the outer layer (not the infill) with a 5mm concrete drill bit. If you do not want this, simply omit it