Densium 4 Ultimate GPU Mod

As owners of our Densium 4 Plus V2 know, GPU support is quite limited, so I have designed the following modification❕

With this modification, you will be able to install graphics cards that were not possible before❕

It's a complete front cover with 4 versions for various graphics card sizes:
 

✅-GPU 235mm (Zotac Twin Edge RTX 4070/4070 Super)

✅-GPU 240mm

✅-GPU 245mm (Zotac Twin Edge RTX 5070)

✅-GPU 250mm (INNO3D RTX 5070 Ti Twin X2)

The "ideal" version is the 235mm one, as it allows installing GPUs WITH THE SAME THICKNESS AS THE ORIGINAL FRONT COVER, WITHOUT CHANGING THE TOTAL SIZE OF THE PC❕

‼️The photos attached to the model are of the 235mm model‼️

‼️Check the specific length of your GPU model before printing‼️

‼️This mod does NOT alter the width of the case, a 2-slot GPU is still required‼️

***IMPORTANT***

-⚠️Print in at least PETG as the temperature in this case is high, PETG, ABS, ASA, and higher are recommended⚠️

-⚠️Supports recommended⚠️

-⚠️4X M3 inserts are used, but it can be used without inserts as it fits quite snugly⚠️

It is also compatible with Densium 4 non Plus, the fit is the same, the different sizes would allow for 188, 193, 198 and 203mm GPUs

This is the first original design I'm publishing, suggestions and constructive criticism are appreciated🫶✍️