Hex Driver Bit Holders

Bit holders to replace the crappy one that I have been using for years. Printed with 3 walls at .2 layer height. Has simple snap latch integrated into the box, but I would recommend slapping a rubber band the case if you expect to jostle it around a bunch. Made the walls of the box slightly thicker and enlarged the pulltab before uploading based on how these turned out. Yours should be more user friendly than mine are.

Files:

• Box - This is the container they slide into - Print open side up, no supports needed
• 48 bit tray - This tray holds 48 standard hex driver bits - Print bottom down
• 24 bit tray - This holds 24 bits plus the sleeve type bit driver - Print bottom down

If you have issues printing check your cooling fan settings, it DOES require good cooling to print well. You will also need ot make sure your printer is calibrated well, if not the drawer can stick.