Frog decorative pot

Frog decorative pot

I printed them 80mm high. Of course, you can scale them up to make them even bigger, they'll look even nicer :)

This is a test print with PLA, if the flowerpot is to be an actual flowerpot and not a decoration, it is better to print it with PETG and with a higher infill percentage.
 

Can also be used as desk containers/organizers for pens/pencils/crayons etc.

Happy printing!

eSUN High Speed PLA+ filament (Bone White)

*0.16mm High Quality @BBL A1; 0.4 nozzle; Fuzzy skin 0.16/0.16; 3 walls, 15% infill

I publish my models only on the MakerWorld.com platform.


 ChatGPT colored a photo of a flowerpot for me, unfortunately I don't have the skills to do such miracles.

I publish my models only on the MakerWorld.com platform.

Happy printing!
 

To print my models before posting them on MakerWorld, 
I use the BambuLab P2S printer + the [BIQU Panda Buildplate CryoGrip] and [BIQU Panda Buildplate CryoGrip Pro Frostbite] plate, 
which has much better adhesion than standard PEI. 
Remember to make sure before you start printing that your plate is ready for printing, it should be clean and degreased.


The models are so detailed that you need to be careful when removing supports for small elements (e.g., hands, fingers). Of course, this problem is significantly minimized when printing at a larger scale. Remember to exercise extreme caution.

Make sure the print profile is adjusted to the filament you're currently printing with. 
Remember to adjust the print parameters to the filament you're printing with. 
Even regular PLA requires different print parameters, especially the Silk or Matte PLA versions. 
Also, make sure your filament is properly calibrated to ensure smooth prints.
 
 

I cordially invite you to check out my other models.

https://makerworld.com/pl/@Atomic99/upload