Search models, users, collections, and posts
The Gondorian
IP Report
Print Profile(2)
AMS, facedown, 0.2mm layer, 2 walls, 15% infill
Designer
3.9 h
1 plate
layered, change marked, 0.2mm layer, 2 walls, 15% infill
Designer
1.7 h
1 plate
Open in Bambu Studio
Boost
35
74
3
1
36
15
Released
Description
Make yourself a good old shield of Gondor!
Careful sizing down as the silver lines are thin. It has built in holes in the tops corners for hanging as I plan to print in ABS and hang it outside. The current colours used are basic black and silver PLA, and metallic blue and silver PLA.
The black/silver AMS facedown version is split into two STLs for easy colour designation and are meant to show the design on both sides of the item (colour runs throughout entire thickness). Import them together if using the raw files.
The blue/silver version shown is layered and has a filament change marked. The majority of the silver areas have been widened on this one so it will print reliably at smaller sizes.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)