Search models, users, collections, and posts
Table Leg Spacer
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
49 min
1 plate
Open in Bambu Studio
Boost
3
11
2
0
10
5
Released
Description
This is a spacer for the table leg to move the table away from the wall to avoid rubbing against the wall. I found one on Makerworld but I didn't need it to hug the skirting. Hope this helps others.
Quick print, should take under an hour and you will need two of these, one for each leg against the wall.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)