Parametric Cable Clip

A universal, highly customizable cable clip allowing you to attach cables to walls using screws or nails of your choice, or simply bundle several cables together.

Click on “Customize” to generate your own!

I tried to choose reasonable limits for various parameters. If they do not fit your needs let me know, they are easy to change.

Customization

Care was taken to set up parameters in such a way where minimal user intervention is required. Just enter your cable and screw diameters, number of clamps you want, and you should be all set. For special cases many more parameters are available and documented below.

Additionally, I provided an assortment of various clamps in the included print profile.

Parameters

Main

• preview
  • Renders placeholder cables and nails
  • Must be disabled before exporting so you don't end up printing them
• cable_diameter - Diameter of your cables
• screw_diameter - Diameter of your screws or nails
  • screw_slop under Misc will be added to this value
• num_clamps - Number of connected cable clamps to generate
• clamp_depth - Depth of the cable clamp (Z axis)
  • If screw sheaths are enabled, the minimum of this value will be capped at screw sheath depth
• wall_thickness - Thickness of the cable clamp wall
• automatic_screw_cap_diameter
  • Sets screw cap diameter to double the screw diameter
  • If the screw sheath is below the top of the cable clamp this parameter will affect the diameter of the sheath so that the cap fits
  • Adjust in Misc if disabled
• screw_sheath_depth_mode - (Y axis)
  • AUTO: sets screw_sheath_depth to double the wall thickness as z bonding is much lower in FDM printing
  • FULL: extends the sheath to the full width of the clamp
  • MANUAL: allows you to adjust the depth under Misc

Misc

• screw_cap_diameter - Diameter of your hardware's cap
  • Used only when automatic_screw_cap_diameter is disabled
• screw_sheath_depth - Depth of the screw sheath (Y axis)
• screw_slop - Value that gets added to the screw_diameter
  •  As the screw hole is inflexible and FDM printing precision in the Z axis is limited this parameter ensures that your hardware will fit.
  • More slop = looser
• chamfer_scale
  • 0.0 - no chamfer
  • 1.0 - chamfer extends all the way to the middle of the clamp
  • To allow the screw head to fit, if the sheath is below the clamp top its diameter will be increased to account for the chamfer
• printable_holes
  • Makes screw holes tear-shaped so that they can be printed without overhangs