Ring Stand

My wife wanted a small ring stand to put by the sink. There were reasons that she could not use any of the ones on Makerworld, so here we have a openSCAD, parametric model .  It can deal with any size plate, and any finger size.  If you needed a ring wand that was 300mm long you could make one.   

In the program I have  the US ring size table, European table, and several others.  However, those functions are incompatible with the customizer so I set the size range for the smallest US ring size to the largest US Ring size.

This code is open source - it is public domain and no warranty.  If you want to boost me if you sell one, great.  If not, that is fine too.  The code is a mess, it is very simple.  Today I replaced the code.  It is properly indented, has a few comments, fewer misspellings, I fixed some formatting issues that affected the customizer messed with the way fillets were produced and added the ability to produce a base that was not round, and I changed it to not put fillets on the outer edge if the edge didn't exist, or if the base was not round.  

I hope you enjoy this. If there is a feature you need, just ask, I'll see if I can put it in without issue, or if I can tell you how to create it.