Adjustable Push Block / Sliding Block

Adjustable Push Block / Sliding Block

For safe processing when sawing and milling, so that your fingers do not get too close to the danger zone.

5 M6 nuts are inserted into the model at layer heights 78 and 340, so that a stable thread is available.

(Pre-set in the 3MF file: 1 stop after 1:41h, second stop after 6:46h)

The handle can be moved variably (to any angle) in the T-slots.

The center part can be moved variably (to the required position to get past the saw blade or cutter) in the T-slots.

The stop can be adjusted in height, according to the material thickness or raised so that it is not used.

Stops are available in 2 widths.

In addition, 2 additional nuts are provided on each side, so that an attachment part can be attached if necessary.

Additional parts required:

• 1x Hexagon head screw M6x30
• 1x Hexagon head screw M6x35
• 2x Cylinder head screw M6x16
• 6x Countersunk screw M6x20
• 14x Nut M6
• Foam for the lower sliding area of the center & side parts

Assembly instructions:

1. Insert nuts (10x) during printing
2. Assemble star nuts (2x) with hexagon head screw M6x30 and M6x35 and T-nuts (4x) with nuts
3. Glue the side parts (2x) and the center part to the underside with foam
4. Insert T-nuts (2x) into the T-slot of the main body on the right and left
5. Slide in the center part and screw it into the T-nut on one side with a star nut (M6x30). Screw the star nut (M6x35) with stop into the T-nut on the opposite side.
6. Screw on the first side part with countersunk screws (3x)
7. Insert the remaining two T-nuts into the upper T-slots
8. Attach the handle and screw it into the T-nuts with a cylinder head screw (2x)

9. Screw in the second side part with countersunk screws (3x)