Search models, users, collections, and posts
longboard footstop
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 60% infill
Designer
2.2 h
2 plates
Open in Bambu Studio
Boost
17
40
7
0
31
12
Released
Description
The designed foot stop is primarily intended for use on our LDP (Long Distance Pumping) boards, but it can also be used on downhill. It has been verified to work without any issues. However, it is recommended to use PETG material for printing, as it is less prone to damage.
The model data for the middleware is: length, width, height - 24mm, 24mm, 5mm, with a 3mm chamfer. You may try to DIY and install your own brand into it.
In addition, you will need two M5 washers to be placed between the bridge screw and the foot stop.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)