GPU Support Standoff
Print Profile(1)
Description
This is an extension standoff for the common GPU sag support that you can find online. For some PC cases where the bottom clearance is larger than the ~110mm that these supports can extend to, this addition will bridge the gap and give you sturdy support to the base of your case.
Here is a link to the one I used: https://www.amazon.ca/Support-Bracket-Graphics-Holder-74mm-120mm/dp/B0C9ZYV1DK
This standoff is sized to 14.50mm (nominal) in diameter, which is a good fit for the above support. The tolerance is pretty loose, this should work for any support between 10mm - 14mm without issue. The standoff will add an additional 60mm to the height of the support.
If you need less than 60mm, please contact me and I'm happy to upload a profile with a smaller height.
Model will print without supports. I recommend upping the wall count to 6 to ensure good structural strength as this part will be under load.
IMPORTANT: Please print in PETG, ABS, ASA, or other heat tolerant material, the interior of PC cases will get to 40C+ which is enough to soften PLA.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)