TheONE roller - flowing spool holder compatible with "the ONE system"
Copyright Claim
TheONE roller - flowing spool holder compatible with "the ONE system"
Boost
19
29
18
Print Profile(1)
0.16mm layer, 5 walls, 25% infill
Designer
3.7 h
1 plate
Boost
19
29
18
0
65
72
Released
Description
Hi guys,
this is an essential accessory if you decide to mount the theONE system!
- super smooth
- works in a very little space
- stable and long-lasting.
Here the link to download the system : https://makerworld.com/it/models/110915
You will love this spool holder.
Small explanation of how to assemble it:
- first you will have to remove the supports. Below see what you will get!
- insert the first bearing into the bottom part.
- insert the roller over the bearing.
- place the pin and push it in (by lightly tapping it with an hammer)
- finish the job by fixing everything with the second bearing.
- here is the final result!
- if the printing tolerances make the insertion of the pin too large, you can block the pin and cylinder with a toothpick through the two holes
Comment & Rating (18)
All
Print Profile
0.16mm layer, 5 walls, 25% infill
The printer's designated space in the nook necessitates placing the AMS on the left side, but unfortunately, all the cables are too short. The standard design recommends positioning the AMS on top or to the right of the printer. Despite these challenges, this printing project has turned out perfectly! The fit is exactly what I needed—couldn't be happier with the results.
The designer has replied
0
Reply
great Job Bug!
(Edited)1
Reply
Replying to @MarcoTiburtini
Thank you! Awesome print!
0
Reply
Print Profile
0.16mm layer, 5 walls, 25% infill
My first more advanced print, that required additional items. Not tested, but should work just fine.
The designer has replied
1
Reply
great job Karol!
0
Reply
Are the bearings 5mm wide?
The designer has replied
0
Reply
Hi Lenny, the project is based on a standard 608z bearing
0
Reply
Replying to @MarcoTiburtini
Thank you :D
0
Reply
where do you get theOne mounting system? Looks interesting
The designer has replied
1
Reply
Hi Ondrovic,
here the system: https://makerworld.com/it/models/110915#profileId-118564
See ya!
1
Reply
Print Profile
0.16mm layer, 5 walls, 25% infill
All parts printed with a nice press fit.
1
Reply
Print Profile
0.16mm layer, 5 walls, 25% infill
works great, good design
1
Reply
Print Profile
0.16mm layer, 5 walls, 25% infill
0
Reply
Print Profile
0.16mm layer, 5 walls, 25% infill
(Edited)
0
Reply
Print Profile
0.16mm layer, 5 walls, 25% infill
0
Reply
Print Profile
0.16mm layer, 5 walls, 25% infill
0
Reply
License
This work is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Related Models
© 2024 MakerWorld