printed perfectly and works incredibly well, I just ended up not needing it (yet) I attempted to use it above my ams but its just a bit too unweildy.

super nice! design works amazing, holds the cable snugly and holds well printed in petg and profile's supports peeled right off, just maybe needs a bottom z tweak. thank you!

0.6mm line width and arachne wall got me near perfect results ;) beautiful model and well designed. Thank you Vuki!!!

color painting caused some oddities on certain seams, the mesh is a bit scuffed in places, but I'm happy with how it turned out.

you're incredible, thank you so much for designing this! the oiling ports for the print in place bearings are genius.

had to scale a bit but fit perfect

flawless print, but make sure you use glue!

b e a u tiful, I used light blue neon green and orange. the neon green looks so good with the backlight my camera just sucks. perfect settings on the profile. thanks!

fit my cabinet perfect, holds standard spices youd find at the grocery store

prints perfect everytime

all I had for green was some inland matte pla so threw that on and made the trunk in matte too, I did 50% infill on the trunk, 100% infill on the hook and top, had some semi gnar undersides on the leaves but thats my fault. Broke a stem removing supports got a bit twisty. Had to expoxy the hook and top on, but it still holds a pound or two of bananas just fine. don't print it in matte and you'll probably be good lol. still happy with it, looks great anyways.

made the smaller one, it printed beautifully in sunlu 2.0 pla+ black.

it was never going to print the letters right on 0.4 without using arachne wall with 50% min, but I got it pretty close first try after inspecting the line layer and I was very happy with the results. Top surface settings also need to be dialed in, bit of shrinkage around all the spots where the black layer sits, more cooling needed on my part I guess? Clear coating helped hid a lot of it. Beautiful design.

Saved me from having to go to the store while I was snowed in and my furnace coil drain hose end fell apart. Printed the 5/8 fitting and it threaded perfectly onto the fitting and the barbs were perfectly snug in the hose. I don't think I changed a thing in the profile. Thank you!

printed fine, just a bit loose, got my A1 this dec, maybe its different?

prints beautifully! I did yellow light blue and pink in inland+