Printed amazingly in Sunlu PLA+, should come in handy for my clinical neuroscience master's later this year! I still need to install the light, but I'm sure it will make a great desk lamp. Advice for printing - I used PETG at the support interface, which made the supports pop right off! I highly recommend doing this, as even though it increases the total print time to 50 hours and doubles the amount of used filament, removing the supports would be extremely difficult otherwise. There is also no support scarring. Just make sure to adjust filament settings accordingly and increase the flushing volumes to 400-500.

printed great in silk pla

Very durable even in PLA

Printed perfectly in PLA, looks amazing

Printed amazingly in silk PLA

works perfectly with PETG, very robust

Printed with good quality in PLA using a low layer height

Printed well in PETG

Printed well with no issues, good quality

Very good quality, printed well with silk pla