printed well, didn’t fit the blaster I have. not the fault of the design

Ran out of filament part way through, and I had to switch. Model and profile are perfect.

love this! great models

I love this model. I find the support material binds to the underside a little to strongly, and clean up is pretty tedious and leaves a mediocre finish. if the support broke away cleaner, I’d give it an easy 5 stars.

Fantastic model! I was about to start trying to figure out how to make exactly this when I stumbled across this model. It works great!

Works pretty well. It seems to be sized for the older MagSafe Charger, which is a tiny bit bigger than the new one. I had to put a small paper shim in place to make it a friction fit. Otherwise, a good model.

awesome project

The new core of my CAD station

Works nice

Holds my scissors nicely

Using half grid was new for me, but it works well.

printed perfect from my phone

I printed at 102%, it BARELY fits. I’ll try again at 105%

Printed as intended. Spins freely.

Outstanding model. The single plate setup was superb, allowing a minimal waste single print. Legs move cleanly.