The AquaLife sink faucet extension comes with two filters included in the package. After these are loaded with impurities, it is necessary to purchase replacement filters. I set out to create a filter model that requires replacing only the cotton component. It is a much more environmentally friendly solution because the filters that AquaLife comes with are on a plastic support and are thrown away whole after use.

Removable UTP cable label. It is useful for labeling UTP cables for good organization when there are many cables to the switch or patchpanel. They can be easily marked with a permanent marker and can be reused if the cable is replaced. I made 2 models, one with the label along the cable and the other with the label perpendicular to the cable. The cable attachment part is identical for both models.

The metal filters on the hood do not retain all the dirt. I made these additional filters to protect the hood fans from dirt. They are made of two components: support and frame. A special thin hood filter is attached between the support and the frame by pressing. I attached it to the hood using 4 10mm/2mm neodymium magnetic pills. I used the filter for a hood with 2 motors and it was necessary to print two pieces.

I wanted a dishwashing sponge holder designed to take up as little space as possible in the sink. It fits rectangular kitchen sinks. I thought that the position in the corner of the sink offered the most free space.

After I put a soundbar in front of the TV I had problems with visibility to the screen and with the remote control working. I made these 4 legs to raise the TV and the problem was solved.

Rummy board legs. To replace lost or damaged legs. In the picture the last leg is the original one that the game came with. I tried to make them identical to it.