Prints flawlessly. The switch (oled edition) has a little bit too much play along the short edge, but it still works just fine.

Prints without issues. The interface between the head and the springs is a bit underengineered but with some superglue it works fine.

Very tight the first time, had to really try to remove the battery again. Still very tight after that but it gets better. Probably the right fit to ensure the battery will still be hold securely after some wear in period. If you'd cut off one of the corners (furthest from the connectors) you'd be able to push the battery out for the first few mm, instead of pulling. Because pulling can be quite difficult with slippery or weak fingers. Will try that in the next few days and add a new profile if it works.

Prints flawlessly and works perfectly fine

Great Print, as usual from this creator.

I don't understand why the 'foot' doesn't touch the table for it's full length and I'd recommend making the bottom surface a little bit concave, so you create clearly defined contact points and prevent swiveling (was fixed by adding 4 anti slip spots). But all in all it works really well!

passt perfekt

Druckt problemlos, braucht nur etwas Schmierung. Rutscht, bzw. kippt aber eher als das es dreht wenn man am Garn zieht

Works surprisingly well for being a plain bearing

Super süß, druckt problemlos

Works as intended and prints super fast an clean

Prints fantastic, I only had to adjust the positioning of the parts on the first plate to make them A1 Mini compatible.

They are a bit excessively long for my regular indoor pots, but otherwise they work well and print without issues.

Only printed the two with the specific compartments for the standard accesories. Those two are flawless.

Prints fine, works well. Nothing else to say.

The little handles of the drawers only attach via friction and a small little lip, the lip slips through the hole if the drawers are ever so slightly stuck and with the slightest touch the handles fall in to the drawers. Everything else is absolutely fantastic, thanks for the great print.

Prints perfectly, more than strong enough for the purpose. Basically just as good as the commercial offerings.

Prints perfectly. Very tight fit against my tool, but given the strength (or lack thereof) of pla (bambu pla matte), maximal contact probably is a good thing. Worked well to tighten the bottom bracket to almost the maximum of my strength (without using my weight or something like that) at which point the ridges sheared off. So I'ld highly recommend printing at least two, one for each side, better three or four to have spares.

The tolerances are a bit wide, so without glue it doesn't work. But the result looks absolutely fantastic, absolutely worth the glueing!

Prints without any issues Some swatches are a bit sticky, but it's mainly an issue with the swatches and not the print. I highly recommend rubber feet and to sand the ramp smooth otherwise the turning is very grindy and the base often binds up with the swatches so the whole assembly spins on the table.