looks great, and fits perfectly, I love the fact that the center part is smaller, this helps with keeping the watch in the right place!

great looking scraper

they clip on quite nicely, however they tend to slide back, and therefore need to be adjusted quite often in order to keep the PTFE tube from leaving marks on the top glass panel

looks great and printed without any issues, great supports as well, only a little bit tricky to get the inner ones out, which i suspect might not be needed.

It’s a really nice design, a little bit sensitive due to some very thin parts, but it looks great and printed perfectly

I added my own supports as the reindeer had quite some unsopported overhang that I was worried might cause bad quality, and it printed perfectly without any issues!

Great and very sturdy design, printed perfectly without any issues!

Had some problems with warping on the first one, but might be because of my build plate, it worked perfectly after I cleaned it