Fits my kindle paper white 6th generation. I hope to use it as a wall display for my home assistant setup.

The mechanism is so cool! The pieces fit together no problem, but I think the tolerances could be tighter. The comb wobbles a lot making it difficult to actually use. I would love to see different versions that: 1. hide the spring mechanism 2. have tighter tolerances 3. move the middle gap allowing for longer comb tines

The deeper drawer lets me hold more stuff

Amazing! It fits the A1 mini perfectly. I printed the main drawer outer casing (white) in PETG to hopefully avoid warping. My only complaint is the rear drawers are unusable without modification. I had to sand down the triangles on the rear (see picture), otherwise the drawers are impossible to pull out. I would love to see a version with long front drawers and no side drawers.

This poop shoot is large, easy to empty, and fits the stand perfectly.

Wrapping the floss takes a bit of practice to get tight, but once you do it’s quick! Infinitely reusable and I use less floss than with my hands.

Works very well!

Stable and fits my toothpaste.

This grip turned out great! The brick slots in perfectly and makes it much more comfortable to hold. Printed in esun red 0.4mm nozzle at 0.12mm layer height (to smooth out the grip) and 15% infill

I printed this for a Mario themed activity in my class. It looks amazing and the students loved it! The top snaps on just as advertised. I didn’t have yellow filament, so it’s printed in eSun gold silk PLA. The gold actually makes it shine in under lights just like in the game!

I printed this dice tower for my Mario review activity for elementary students. It looks great and students loved it! As others have noted, it doesn’t tumble the die very well and about 20% of the time the die doesn’t fully come out the bottom. The pipe could be a little larger with some steps inside to help randomize dice better. The print tolerance, especially with the brick block, are too tight. I had to sand down the inside to get it to fit around the pipe.

It doesn’t fit my cheap “scitools” calipers as the holes are not wide enough, but it’s still usable. It would be great if the words “caliper radius tool” and image were a separate object and raised in order to print them without an AMS.

I stuck this on a gridfinity plate so I could slot it into the V3 storage stand. The blades are a bit difficult to get out, but I don’t need to change blades that often anyway.

Awesome attachment for the V3 storage stand! This keeps my swatches and scrapers in easy reach.

This is a super cool print. My only suggestion is to make the tolerances tighter, as the comb wobbles too much.

I made this trophy for our round 1 tournament. The trophy was easy to put together and the plate snapped right in. I used esun pla silk gold color, and regular pla for black and red.

This clip is not compatible with Mazda MX5 Miata. It is too big and slides around the visor. Check your car before printing. The magnetic part is great. Thank you for providing the STLs so it was easy to adjust to my magnet size. One 6mm diameter magenet provides plenty of closing force. I printed in esun black petg and esun black TPU 95A.

My first big TPU print and it turned out great. The supports were a bit difficult to remove. I used esun TPU 95A in black. It’s not as soft as I thought it would be and it doesn’t bounce much at all. I will need to get some different material and try again.

The wife wanted a 30mL bottle with scoop for her cream, so I had to resize the 50mL and make it smaller. I printed the ring and top cap with black TPU 95A and the bottle with bone white PLA+. Her review: “the cap should be smaller with less spins to open and close. The scoop doesn’t need edges, it just makes it more difficult to clean. The scoop should be a few mm longer so it doesn’t slide around so much.”

This is a great fit for my wolfbox mega flow 50.