This is a great model and profile, there are many similar designs, but i chose to go for this one due to its good looking design, quick print speed, and lower filament usage than others while still keeping the same durability, and works in the ams/2pro and it even has the little sticker spot which not all have!

I have printed this many times (mainly to give as gifts) and they all have turned out great and look good, just one small thing is when printing the pot the edges where it extends out a bit can be a bit 'stringy', and also i would recommend printing the flowers at 100.8% size to more easily get them on and off, other than that its a great model! 👍

Good design, quite minimalistic (compared to some), does what its supposed to, and prevents cable sagging. I printed one for each of my A1 minis and my A1

Does what its supposed to, simple, fast print, low filament cost, definately worth it! 👍

This was the only good looking minimalistic cable holder/suport for the a1 mini i could find, i was specifically looking for one that utilised the gap on the other side of the filament cutter and this one fit all my needs perfectly, and i ended up printing this for my 3 a1 minis and they are great, and a must have to prevent cable sagging, ive found no flaws in this model!!

This is a must have for any a1 owners 100%. Its small, compact, quick to print and lasts a good while before it needs emptying, however i would recommend a bigger bin if you use an ams lite as they produce more poop.

Very good, prevents cable from dangling onto build plate, whilst also being quick and easy to print however, it doesnt FULLY remove the sag, as some remains present but nothing near as bad as without it.

Its a super quick and easy, cheap to print and does what its supposed to, i highly recommend printing this to anyone who owns an a1 without an ams.