its ok, I would remove the lowest line so it doesn't make confusion about measurement

cool print. I made it 150% big and kids love it

cool model, i printed it a little bigger (150%)

great and smooth

its good, looks great in yellow petg

good one. fits great original series x gamepad but doesn't fit anything else unfortunately

I really like this design, could be a little heavier on bottom though

good but blocks hdmi port in my setup. if you plan on using it - shave it off. otherwise its a little to tight, so fitment is snug. feet need to be removed from pc prior to installation.

life saver 😀

good one

I love this one, it can be used to ziptie stuff to it :D

it does the job

great print

good one. if you press inserts from inside it work a little better and you can accommodate longer screws. I recommend using one size larger washers. the place for bolt itself could be tighter for more clamping surface.

cant go wrong with it. i use them as socket holders 😀

its ok

little tight to put in the magnet bar but i thinks its better that way than too loose :)

good print, a little wobbly and not really flush with pegboard but its ok for what it is

good print

good print