Required some sanding to fit

Had to do flow calibration on my 0.2 nozzle and bump the K value by quite a lot, but that's probably not this model's fault. White Bambu Lab PLA on blue Sunlu PLA+ didn't work well — readability was low. Changed to black on white and it's great.

Had to do some sanding to make some of the LEDs fit

Not sure if the color switch between the first layers and the color accent is intentional. I simply repainted the first layers to cut down on filament switches.

Got minor adhesion problems between some layers on the upper exterior, a few mm above where the inner cone starts. Should only be cosmetic though. I'll probably reprint this one when I get my hands on some PETG.

Cute! The small hinges were a bit tricky to break in. a bit of silicon spray helped a lot.

Clever solution with the flexible underlay. Would prefer my aircraft a bit less chonky, but that's just me. :)