Search models, users, collections, and posts
Bio
Hardworking guy balancing life, learning, and work. Have spent the last 27 years in various roles, from serving in the Navy as a technician to being a Corrections Officer to supervising the Meat and Produce department at Walmart to Supervising Lumber and Hardware at The Home Depot. Now going to school to get back to my roots and diving deeper into electronics and math to hopefully become a Biomed Technician.
Always learning, always leveling up.
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
decided to just go with some flickering tealights that I currently had on hand from hobby lobby. think the flickering effect looks better anyways than the steady light from the Bambu lamp kit. might see if I can make an insert for the base to fit the tealight so it isn’t sliding around. But came out great.
Share
0
0
0
Works great. will be helpful when trying to judge if I have enough of a color to complete a print.
Share
0
0
0
The print itself came out fine. Only issue I had is with hardware. I was impatient and bought hardware from hardware store and while the threads and length were correct the screw head was a wafer type and caused interference on the latch side because heads were touching and not allowing box to close properly. I just needed to pay better attention when substituting hardware. The print itself was perfect. I will submit photos once I get the correct hardware.
Share
0
0
0
Share
0
0
0
No more data