I know that I can change the strength of the print. Due to the fact I just hit print & go it is not as sturdy as my 1st smaller one is. I will say that the honeycomb design is nice. I changed the rating from a 3 to a 4 at the request of the designer explaining why it is so thin. I since changed back to my normal one.

I actually like this. only issue I had was that my 3 tools from AFA Tooling fit tighter than I would have liked so I pulled out a drill bit that is actually.0025 larger & WALA all fixed & all set. I like so very much so that I printed 2. 1 holds 1 deburring tool & 2 counter sink tools with replacement blades & the other holds another AFA Tooling deburring tool, replacement blades & 2 center punch.

I love the style of this draw the I printed 2 gray & 1 black.

I love the style of this draw so much I have printed 2 black frames on gray draws and a gray frame on a black draw.

just realize that I need another one with 2 slots. I thought about printing the 4 but the 2 work better.

it is a good replic. it’s going to make a nice addition to my Division Video game Diorama