A little tricky to get the tab to slot, but it only took a minute or two of finagling, and well worth the effort. I highly recommend bending the tab down a few degrees, as it will help the plate sit flush with the cap.

Be sure to enable supports under the belly. Printed beautifully in MatterHackers quantum green raspberry PLA on an Overture silk gold rock. Supports were easy to remove, and the detail is amazing.

I used a support interface layer, and the supports were still quite difficult to remove. After 22 hours of printing and about 90-120 minutes of careful work a pair of needle-nose pliers I got a beautiful result.