I've previously printed an earlier model of this sword and the endcap would frequently fall off.. although it may be an issue at times it was good thing to have that because when you're playing with the swords and one sword breaks you can easily replace the part now the cap is actually printed in place so it cannot come off I would have liked to have seen a model where the end cap was threaded so if you needed you could pull it apart and replace it. over all i think this is a great sword and is over looked to often. Thank you to the maker, cheers and may there be many more

This is the best print I have had yet, by far (printed on a P2S). The finish and infill make this modle feel sturdy. I printed this with all the defalt settings and with Bambu labs PLA red and white filaments. I was worried because it didn't print with abs that all the gears would strip or the teeth would break but it held up well. I strongly recomend this print.