Pronted well, no issues. I’ve yet to see if it works but the logic certainly makes sense.

Printed very well. Gotta be careful when installing to ensure that the back piece engages correctly but with a little care it fits well and is holding up so far.

Easy print, perfect fit!

This was such a beautiful print but I ran into one issue that I could not figure out how to avoid. The heart kept printing with a support that was connected to the base of the print and not the printbed, I tried checking the box to only connect to the printbed but it would not change. It was easy to remove but left a ring on the base where the support was attached (see photo). I’m sure there was a simple solution for a more seasoned user but I personally couldn’t figure it out.

I purchase a lot of Inland filament from my local Microcenter and apparently their PLA+ cardboard spool has these strange dimensions and does not fit on a standard BL spool. This one was perfect, zero issues. Just wish I found it before trying (and failing) to custom design my own.

Thinner than I expected but cute print overall

Excellent print! Had a tiny issue with bridging across the slot on the base but super easy to clean up with a razor so I still say 5 stars.

Excellent print! Great detail and the pieces fit together perfectly!

These were great, quick prints with great quality. Highly recommend for your next gridfinity project.

These were an easy print and the drawers fit perfectly. The only reason I didn’t give it a perfect 5 stars is because the top portion (which is split in two prints) didn’t fit perfectly. I will try to modify them so the sides are a bit wider so that there isn’t any side to side play once in.

Easy print , easy assembly. This worked as expected making the filament connector much easier to use. Nice touch to have it gridfinity compatible also.

Bic mini is a perfect snug fit. Printed in a matte Green/Brown which came out great. Only thing I added was a solid torus to the top for a lanyard loop. I have these stashed everywhere now.

At first it seemed as though this needed to be scaled down a tiny bit but after some quick measuring I tried giving it a little tap and it slipped in perfectly! As stated in the description, make sure you line up the notches. Removal once the spool is finished may require ripping off the cardboard but that’s simple.

These printed great, no issue however I’m not sure what I’m doing wrong with using them. After looping the filament end back over and placing into the clip the whole thing starts to loosen.

Scaled it down to 200mm and it is a much more snug fit which is to my liking. Fits fine as is but seemed slightly loose to me.

I’ve made 3 different spool designs, this remains my favorite balance between speed, strength and overall design. I used PLA and so far I have no complaints. Oviously not ideal if you are rough with your spools or if you stack them on top of each other; unless you print in stronger material.

Awesome print! Screw holes were perfect. Obviously don’t overtighten and you’re good.

Awesome print! Screw holes were perfect. Obviously don’t overtighten and you’re good.

I should’ve scaled it up a bit but still looks awesome! My daughter loves it!