print came out great. I used marble pla

nice design. will print another for the other side of the desk.

replaced the original that had a tab break. fit well

fit the mouse very well quite comfortable. would be great if it could connect with the wrist rests.that are available.

I needed this specific shaped top to fix a lamp. I scaled it a bit and it fit very well onto the broken top thanks

Very nice fit of the clip at the front. holds very well also the tubes fit very smoothly. this one is much lighter then other prints that I found would fall off.

fit perfect. exactly what I needed to fix my trunk fabric

printed well. but for some reason I had a crazy high amount of support bits added. still worked well. I tested it at the range today.

Great design and look. left back corner had some print issues with both sized shelves. but not a big deal

Excellent design and looks very close to the real thing. I changed the white part to print face down as the textured look matches the odyssey white hot putter insert better. And I changed the infil to 100% so you don't see the infil lines. I also added a extendable putter shaft from another project. Thanks for the design

great design

needs some glue

great clips

very tight fit

looks to fit. need to add the connector

I like the way the hinge works

fit on very smoothly. very fun addition

works.well

great little.tool.box

has been very nice to use