Yea boi

Works also with Leifheit laundry hanger

You've knocked it out of the park with this one. Love it Personally I'd only change so that the hole for the earbuds is a bit bigger + a version for the Kiwi Elite Battery strap would be nice. The bobo one almost fits (maybe off by a mm or 2)

Good, but in PLA. You've gotta be careful not to pressure too much, otherwise it breaks

Came out beautifully and thanks for the extra profile!

Printed with fuzzy skin

Very right fit for Riffmaster, but doable

Verrry thiin

Edit: Even though brim was activated it still lifted of the plate.

Came out perfectly

Not recommended for coolplate supertack. They'll most likely move and destroy the print. So either use textured pei or glue. I basically used both because I was scared after 2 failed prints. Seems like a Me problem tho since no one else talks about it

Came out very good!

Better than the original and better than the other big Series X faceplate. But I don't know why, for me it never fits perfectly

Tolerances are really tight, I did 2 prints with both of em I've had problems getting the connectors in. Also, the tutorial doesn't really help much. Seems like a Me problem tho since everyone else is doing fine

Perfection. Also for the Ali express ones

For 5 layers a bit to small but for normal toilet paper perfect fit