Multiboard console holders
Print Profile(1)
Description
I fell in love with the multiboard system, I've designed and printed all those holders for my consoles in a day.
You can see them getting better and better as I learn more about designing, some of them were greatly inspired by other creators.
No supports needed, no special filament, no headache, 2 plates and roughly 9h of print time will give you 16 holders.
All supports use 2 snaps except the vmu which only need one.
Some holders may not be used by a lot of you, like the unhinged or vertical DS - for a pokedex shelled nds.
The vmu is also special as it is a kite circuit gem and I don't see why anybody would display a simple vmu - other than special editions.
All holders should have a little bit of wiggle room, this is to insert a small patch of felt, I use sticky felt with a width of 1mm max.
Do not worry about the slight overhang on the first lines, this is normal and necessary to fit well in the snaps.
Boost Me (for free)
Some may be a bit too simplistic or not good enough for you, if you want me to redesign some of them or design some new ones feel free to drop a boost !
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (21)