Yet another drill bit stand. This one has been optimised for my needs and includes 0.5mm steps from 1 to 10mm.

I've included a 3mf file for a two colour print on a Bambu Lab with AMS for Bambu Slicer. You could also do a filament colour swap near the end so that the raised text is printed in another colour and make it more visible. The filament colour swap is setup in your slicer software. Setting up the filament colour is easy in Bambu Slicer, other slicers probably, too.

Once printed, a small amount of attention will be needed to fine tune the hole diameters to ensure a good fit. Just use the bits to carefully adjust the hole size to match the level of snugness fit you prefer to work with. Keep in mind with all drill bit stands, over time the holes do loosen up a little more.

My print is made with eSUN PLA+ 1.75mm black and red filaments, with 0.2mm layer height and 15% infill on a Bambu X1 Carbon printer.

I hope you can find this print useful, too.