Fixing Brackets
Print Profile(1)
Description
90 degree fixing brackets
I needed various fixing brackets for a DIY job I was working on that had an Inner curved angle and centre wedge both for added strength.
I printed these in PETG however these would likely print just as good with PLA depending on your requirements.
The screw hole is 5mm
Current sizes are(mm):
30x30x30w - 3mm thick
30x20x30w - 3mm thick
20x20x30w - 3mm thick
20x20x15w - 3mm thick
20x30x15w - 3mm thick
30x30x15w - 3mm thick
Will look to expand these going forward, add a comment if you have a specific requirement.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)