Search models, users, collections, and posts
Wall/Table gap stop
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
52 min
1 plate
Open in Bambu Studio
Boost
8
27
0
0
18
10
Released
Description
Bits of printer filament kept falling down a thin area to the side of my printer where there was gap between the wall and table. This was my first ever printer design so it was nice to find a solution to the problem.
The link between parts isn't aligned absoloutely perfectly but I've no need to perfect this as it is functional enough for me.
Extend and shrink as needed.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)