8BitDo Controller Multiboard Mount Ultimate 2C

Buy me a coffee? https://buymeacoffee.com/practical3dp 
The correct controller to use with this holder is this one: https://amzn.to/3Lsbo8E (this is an Amazon affiliate link) 

8BitDo Ultimate 2C Wireless Controller Multiboard Mount (REMIX):

I couldn't find a multiboard mount for this controller, so I remixed another controller holder to make this one :) The holder attaches to the Multiboard with bolt locking. More instructions below on how to use the holder. 

NOTICE: This mount is a perfect fit for the 8BitDo Ultimate 2C controller. I cannot guarantee compatibility with other controllers 

How to use/assemble:

1. Print the holder, snaps, and locking bolts.
2. Attach two moderate-weight bearing snaps to the top of the holder (The build plate side of the snap goes toward the holder) 
3. Attach two regular multiboard snaps to the bottom of the holder 
4. Screw the four folded locking bolts in, and the holder is complete

Moderate weight bearing snap: https://than.gs/m/1311034?image=2135390
Regular multiboard snap: https://than.gs/m/1311031?image=2135383
Folded locking bolt: https://than.gs/m/1310061?image=2134523
 

Print Instructions:

Filament: Any, PLA or PETG recommended 
Layer height: .16-.2
Infill: 10-15% infill
Walls: 2-3
Supports: Manual tree supports underneath the 4 overhangs on the back of the part 
Wall generation: Arachne
Post Processing: Remove any stringing by hand and then use a torch or heat gun to remove any remaining stringing.

LICENSING: You may not use this design or file for commercial purposes. See Full Licenses Here:
Creative Commons - Attribution - Non-Commercial - Share Alike
https://www.multiboard.io/license

Original Designers: 
https://www.multiboard.io/parts-library
https://makerworld.com/en/models/964616-8bitdo-ultimate-2c-ikea-skadis-stand-mount#profileId-934933